Rivera Quiana Studio Guía para resolver problemas descargar pdf (Pagina 15)

Quiana and Fandango 1.0 p 15

Driving two speaker cabinets

WARNING: TO REDUCE THE RISK OF FIRE

OR ELECTRIC SHOCK, DO NOT EXPOSE

THIS EQUIPMENT TO RAIN OR MOISTURE

LINE OUT

560 Ω

TOTAL MIN. Z 8 Ω 55 W. RMS

SPEAKER JACKS IN PARALLEL

USE FIRST

SPEAKER 1

SPEAKER 2

8 Ω 8 Ω

In this configuration, the Quiana/Fandango is driving two speaker cabinets with identical

impedance's. Using heavy-gauge speaker cords, connect the output jacks labeled

Speaker 1 and Speaker 2 to the speaker inputs on extension cabinets with a minimum

8-ohm impedance and power-handling capacity of 60 watts (for 50W Quiana/Fandango

55). You can also hook up two 16-ohm cabinets, but avoid if possible the use of two 4-

ohm cabinets, because the overall impedance load will be below what is optimum for

the amplifier and sustained use could result in overheating damage. When using two 8-

ohm cabinets, set the Quiana/Fandango's Impedance Selector to 4 ohms. When using

two 16-ohm cabinets, set it to 8 ohms.

Running two amps in parallel without a Y-cord

HIGH

GAIN

LOW

INPUTS

HIGH

GAIN

LOW

INPUTS

FROM

GUITAR

The Preamp and output amp sections, as well as all controls, function normally in this

setup. Use a shielded cord. Note: Make sure speaker cabinets are connected to both

RIVERA amps.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Sin comentarios

Rivera Quiana Studio Guía para resolver problemas Pagina 15